Introduzione

If the screen is cracked or not working it may be necessary to replace it. This guide will show how to conduct a screen replacement.

Place the meter face down, so the back panel and screws can be seen.
  • Place the meter face down, so the back panel and screws can be seen.

Aggiungi Commento

Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
  • Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

Aggiungi Commento

  • Remove the back panel of the device by lifting upward.

  • Remove the battery from the meter before continuing.

Aggiungi Commento

  • Remove the four 7mm Phillips screws holding the circuit board in place.

Aggiungi Commento

  • Gently lift the circuit board away from the device casing.

  • Remove the battery after removing the back cover to reduce the chances of short-circuiting the circuit board.

Aggiungi Commento

  • The screen is located at the top of the device.

Aggiungi Commento

  • Carefully remove screen from device by lifting upward.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Anna Kihm

Membro da: 13/10/2014

793 Reputazione

5 Guide realizzate

Team

Clemson, Team 2-4, Benson Fall 2014 Membro di Clemson, Team 2-4, Benson Fall 2014

CLEM-BENSON-F14S2G4

4 Membri

6 Guide realizzate

my multimeter display is broken, where can i buy a new one?

allwynrajkumar - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 31

Tutti i Tempi: 1,197