Introduzione
If your camcorder LCD screen is scratched, cracked or defective in any way, it will have to be replaced. This guide requires some tools and time.
Cosa ti serve
-
-
-
Locate battery compartment cover. Turn the device over and locate the battery compartment cover.
-
Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.
Chiedi a FixBot
-
-
-
Locate the grey latch and move it aside. The battery is spring loaded and will pop up.
-
Remove the battery.
-
-
-
-
Using the Phillips #000, remove the two screws on the LCD panel.
-
Using the Phillips #000, remove two more screws near the LCD panel swivel point.
-
-
-
Use the plastic opening tool to remove the plastic cover from the LCD panel.
-
-
-
Locate and remove two screws on the logic board.
-
Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
Team
USF Tampa, Team S1-G4, Nance Spring 2017 Membro di USF Tampa, Team S1-G4, Nance Spring 2017
USFT-NANCE-S17S1G4
4 Membri
10 guide realizzate
