Introduzione

Removing the front cover gives access to lens housing, and allows removal of the top cover.

Parti

Nessuna parte richiesta.

Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
  • Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.

Aggiungi Commento

Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
  • Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.

Aggiungi Commento

  • Remove the battery from inside the battery housing and set the cover aside.

Aggiungi Commento

  • Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.

Aggiungi Commento

  • Remove the 6.4mm screw from the inside of the flash bezel.

Aggiungi Commento

  • Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.

Aggiungi Commento

  • Remove the 5.6mm screws behind the battery cover.

Aggiungi Commento

  • Remove two 6.4mm screws on the latch mechanism on the right side of the camera.

Aggiungi Commento

  • Remove the 6.4mm screw on the top of the inside edge of the battery hole.

Aggiungi Commento

  • Starting at the flash, carefully pull the front cover away from the camera.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mark

Membro da: 20/04/2011

88 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 8-9, Regan Spring 2011 Membro di Cal Poly, Team 8-9, Regan Spring 2011

CPSU-REGAN-S11S8G9

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 2,080