Aggiusta la tua roba Comunità Store

Axess SPBT1031 Buttons Replacement

Introduzione

This guide will be helpful for repairing the buttons in the speaker if the troubleshooting page recommends that you replace the battery. This is a necessary step when you have determined no other way to repair your current battery. Be wary of accidentally damaging other parts of the device when replacing the buttons.

Cosa ti serve

  1. Axess SPBT1031 Buttons Replacement, Red Interface Plate: passo 1, immagine 1 di 1

    • Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.

    Modifica

  2. Axess SPBT1031 Buttons Replacement: passo 2, immagine 1 di 1

    • Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.

    Modifica

  4. Axess SPBT1031 Buttons Replacement: passo 3, immagine 1 di 1

    • If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.

    Modifica

  5. Axess SPBT1031 Buttons Replacement: passo 4, immagine 1 di 1

    • Separate the red interface plate from the black face plate by pulling them apart.

    Modifica

  6. Axess SPBT1031 Buttons Replacement, Buttons: passo 5, immagine 1 di 1

    • Take the red plate and the motherboard and pull apart.

    Modifica

  7. Axess SPBT1031 Buttons Replacement: passo 6, immagine 1 di 1

    • Push the set of buttons inward from the outside of the red plate and peel off from the inside.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 1,583