Introduzione

This repair will need:

A T8 Torx screwdriver.

Parti

Nessuna parte richiesta.

After completing the initial disassembly, you may proceed to hard drive replacement.
  • After completing the initial disassembly, you may proceed to hard drive replacement.

After completing the initial disassembly, you may proceed to hard drive replacement.

Aubrey - Replica

First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.
  • First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.

  • Next, you will remove the mounting frame and the plastic shield.

First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.

Aubrey - Replica

Next, you will remove the mounting frame and the plastic shield.

Aubrey - Replica

  • You can use a spudger (tool shown in photo) to remove the ribbon cable from the hard drive.

You can use a spudger (tool shown in photo) to remove the ribbon cable from the hard drive.

Aubrey - Replica

  • Carefully, pry the ribbon away from the pins.

Carefully, pry the ribbon away from the pins.

Aubrey - Replica

  • Attach the ribbon cable to the new hard drive and follow steps 1-3, in reverse, to complete the installation.

Attach the ribbon cable to the new hard drive and follow steps 1-3, in reverse, to complete the installation.

Aubrey - Replica

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Tyler

Membro da: 10/04/2011

129 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 20-66, Walters Spring 2011 Membro di Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 3,647