Meta Quest 3 Initial Setup Guide

Initial Setup Guide

FOR VR HEADSETS (META QUEST 3)

Version 1.0

F

Turn headset on/off

Turn the headset on or off by press and hold the power button on the left side of the headset.

B A X Y

Controllers

Any button will wake up the controller after you turn on your headset.

Charging the Headset

F

Charge using compact charging dock

Connect charging line with charging port.

B A B

Controllers run on batteries

Use AA batteries to run your controllers

Checking Battery

D

Check the light on the headset

A little yellow or red light will be lit on the top-righth side of the headset when it is low in battery.

Meta Quest Headset Left Controller Right Controller

Wi-Fi

Bluetooth

Boundary

Check from quick settings

A) Press the quest button on the right controller to open up the universal menu.

B) Open quick settings by pressing the trigger down.

C) The amount of battery left in the headset as well as controllers are shown on the top left.

Setting Boundary

The first thing when turning on the headset is to set the work area and floor level. This must be done correctly because it determines your ‘safe area’ inside the simulation.

M

Touch the floor

Simply touch the floor with one of your controllers, and you are set.

1.5 m 1.5 m

A good size for your work area is a $ 1,5 \times 1,5 $ meters square.

This allows for some movement but prevents people from moving around and potentially hurt themselves. Make sure to include a buffer between the work area and surrounding walls.

Stay Within The Boundary

1.5 m 1.5 m

Re-doing Boundary