99 3000348

Part Install Instructions

Top Load Washer Main Board (with 7-segment display)

Programming -WH22X35757

Parts Included:

• Control Board

Overview - Procedure for programming new control boards when all LEDs are flashing.

1. Press Start button. LEDs will stop flashing and the personality ID can be selected.

• Models with seven segment display will show the personality ID number in the display.
• See Personality ID numbers, by model number, on page 2

2. Press and release the Start button to increment to the next personality ID number.

• The first personality shown may be '0' and all cycle status LEDs will be off
• When the end of the ID list is reached, the control will wrap around to the beginning of the personality ID number list.

3. Press and hold the Start button for three seconds when the correct personality ID number is in the display.

• This will save the personality ID number and the control will go to an idle state.

NOTE: If an error is made programming the control or the LEDs are not flashing, enter Field Service Mode as shown on the last page of these instructions. Use service mode test 17 to enter the correct personality.

Personality ID Chart

**Table Caption: This table maps appliance model numbers to their corresponding personality IDs, indicating that different models can share the same