Parrot SKYCONTROLLER

Parrot

User Guide

Table of Contents

Before starting.....4
Charging the battery.....4
Installing the battery.....4
Installing the neck strap.....5
Installing a smartphone.....5
Installing the sunshade cover.....7
Connecting to the Parrot Bebop Drone.....8
Displaying a video feedback.....9

Piloting .....10
Orienting the Parrot Skycontroller.....13
Orienting the antenna.....14
Movements.....15
Photos and videos.....15
Return home.....16
Battery.....16

Using FPV glasses.....17
Wi-Fi .....18

Updating.....19
General information.....20
Safety precautions and maintenance.....20
Wi-Fi.....20
Warning on invasion of privacy .....20
Battery.....21
Warranty.....21
Modifications.....22
Disposal of this product at the end of its life .....22
Declaration of conformity.....23
Registered trademarks .....23

Before starting

Note: For easy reading, iPhone $ ^{\circledR} $, iPad $ ^{\circledR} $ and other compatible telephones or tablets are referred to as 'smartphones' in the manual.

Charging the battery

1. Insert the plug converter corresponding to your country to the transformer.

2. Plug the battery to the charger.

3. Plug the charger to the mains.

The charger's led lights up in red when charging. Once the battery is fully charged, the led turns green. The battery takes about 1 hour to charge.

1

Installing the battery

1. Connect the battery to the Parrot Skycontroller power cable.

2. Insert the battery into the battery compartment.

Click

Installing the neck strap

Before the first use, attach the neck strap to the Parrot Skycontroller. Before each use, ensure that the neck strap is correctly attached.

REC

Installing a smartphone

The Parrot Skycontroller can be used with a smartphone or tablet in order to have a video feedback.

1. Place your device horizontally onto the appropriate support:

• use the upper compartment for smartphones (A);

• use the bottom compartment for tablets (B);

• use the adapting support (supplied) for 7-inch tablets (C). Unscrew the removable part of the bottom compartment to install it.

3. Slide down the upper part of the support by pushing it slightly.

4. Screw the bottom handwheel located on the back of the Parrot Skycontroller to lock your device on the support.

Note: Ensure that the Parrot Skycontroller does not apply pressure on the buttons of your smartphone. If it does, move your smartphone towards right or left.

A REC 00000 Parrot 00000

B REC 00000 Parrot 00000