Roku Indoor Camera 360 SE (CP1000X) - Base Assembly Replacement
Introduction
This guide covers removing the base assembly from the outer housing. The base assembly is a plastic platform that contains the main board (DF3-MCU-501-V2.3), the pan motor (24BYJ48 461C), base gears, and the camera FPC connector.
Prerequisites
Complete the Back Panel Replacement guide first.
Step 1 - Squeeze the case outward
With the back panel removed, gently squeeze the outer case walls outward. The base assembly sits inside the housing held by friction and plastic clips.
Step 2 - Lift the base assembly out
Once the case walls are flexed outward, the base assembly will come loose. Carefully lift it out of the housing.
Be careful - the camera assembly is still attached via the FPC ribbon cable and mounting bracket.
深圳市一诺微特电机有限公司 24BYJ48 http://www.yinuomotor.com A211230 DC 5V 461C
Base Assembly
深圳市一诺优特电机有限公司 1 461C DC 5V 24BYJ48 Tel:0755-28230809 A211230
Base Assembly Angle 2
Result
The base assembly contains:
Main board (DF3-MCU-501-V2.3) - with SoC, SPI flash, WiFi module, UART pads, motor/speaker connectors
Pan motor (24BYJ48 461C) - held by 2 screws
Base gears - worm gear and spur gear for pan rotation
Reassembly
FPC connector - shielded ribbon cable connection to camera board
-
Align the base assembly with the housing.
-
Press it back into place until the clips engage.
-
Follow the Back Panel Replacement reassembly steps.
