Multimedia Projector MODEL PDG-DWL100

O

PROJECTOR

Table of Contents

Table of Contents

Usage Notice
Precautions.....2

Introduction
Product Features.....5
Package Overview.....6
Product Overview.....7
Projector.....7
Connection Ports.....8
Control Panel.....8
Remote Control.....9
Remote Control Battery Installation.....12
Remote Control Operating Range.....12

Installation
Connecting the Projector.....13
Connect to Computer/Notebook.....13
Connect to Video.....14
Powering On/Off the Projector.....15
Powering On the Projector.....15
Powering Off the Projector.....16
Warning Indicator.....17
Adjusting the Projected Image.....18
Adjusting the Height of Projector Image.....18
Adjusting the Projector Focus.....19
Adjusting Projection Image Size.....19

User Controls
On Screen Display.....20
How to operate.....20
Image(PC Mode).....21
Image(Video Mode).....23
Screen.....25
Setting.....27
Setting/Network.....30
Language.....31
Information.....31
Controlling the Projector From Web.....32
Configuring the Network Setting.....32
Home Page.....35
Control Panel Page.....36

Network Setting Page.....37
Security Setting Page.....38
Alert Setting Page.....39
Logout Page.....40

Appendices

Troubleshooting .....41
Replacing the lamp .....46
Cleaning the Air Filters .....48
Specifications .....49
Computer Compatibility (Analog) .....50
Computer Compatibility (Digital-HDMI) .....51
Configurations of Terminals .....53
Terminal : Analog RGB (Mini D-sub 15 pin) .....53
Terminal : Mini DIN 8-pin .....53
Regulation & Safety Notices .....54
Serial Control Interface .....56
Operation .....56
Functional Execution Command .....57
Status Read Command .....58
Use of Telnet .....59
PJLink Notice .....60
Dimensions .....61

Precautions

！

Follow all warnings, precautions and maintenance as recommended in this user's guide to maximize the life of your unit.

Warning- This apparatus must be earthed.

Warning- Do not look into the projector's lens when the lamp is on. The bright light may hurt your eyes.

Warning- To reduce the risk of fire or electric shock, do not expose this projector to rain or moisture.

Warning- Please do not open or disassemble the projector as this may cause electric shock.

Warning- When replacing the lamp, please allow unit to cool down, and follow all replacement instructions.

Warning- This projector will detect the life of the lamp itself. Please be sure to change the lamp when it shows warning messages.

Warning- Reset the "Lamp Counter Reset" function from the on-screen display "Setting" menu after replacing the lamp module (refer to page 29).

Warning- When switching the projector off, please ensure the cooling cycle has been completed before disconnecting power. Allow 120 seconds for the projector to cool down.

Warning- Do not use lens cap when projector is powered on.

☐ Warning- Turn on the projector first and then the signal sources.

Warning- When the lamp reaches the end of its life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn back on until the lamp module has been replaced. To replace the lamp, follow the procedures listed under “Replacing the Lamp”.

Usage Notice

Allowing the proper amount of space on the top, sides, and rear of the projector cabinet is critical for proper air circulation and cooling of the unit. The dimensions shown here indicate the minimum space required. If the projector is to be built into a compartment or similarly enclosed, these minimum distances must be maintained.

SIDE and TOP REAR 1.5' (50 cm) 1.5' (50 cm) 1.5' (50 cm) 3' (1 m)

Warning

Avoid positioning the projector as described below when installing.