Arkray GLUCOCARD Vital Quick Reference Guide

GLUCOCARD® Vital™

arkray

BLOOD GLUCOSE MONITORING SYSTEM

Quick Reference Guide

PERFORMING A BLOOD GLUCOSE TEST

Step 1

Remove GLUCOCARD Vital Test Strip from the bottle. Immediately replace the bottle cap tightly. Insert test strip as shown in diagram. The meter will turn on automatically

GUCOCARD Vital

IMPORTANT!

Insert into meter this way

Test Strip Port

Contact Bars

Reaction Site

Sample Application Tip

88:88 AM DAY MEM AVG mg/dL !88.8!

Make sure all parts of the display screen appear.

Step 2

Obtain a blood sample. Apply blood to the end of the test strip. Capillary action will pull the blood to the reaction site. The meter will start to count down when it detects that blood has been applied.

Do not add blood on top of the test strip, as you may receive an inaccurate result.

Discard strip if meter does not start to count down after blood drop is applied.

IMPORTANT: The minimum sample volume is $ 0.5 \, \mu L $. Smaller samples may not start the meter or can start the meter count down and provide an "E13" error message. Ensure blood completely fills reaction site.

GUCOCHED Vital SKYBRY CORRECT

Enough Blood Not Enough Blood Too Much Blood

DO NOT add blood to the top of the strip. You may receive an abnormal (high) result.

INCORRECT

Step 3

The test result and date/time is displayed in 7 seconds. The result will be automatically stored in memory

Step 4

Results will be shown in units of mg/dL.

When the test is done, remove test strip. Dispose of test strip carefully. The meter shuts off automatically when you remove the test strip.

Record result in your logbook.

A lancet should only be used once. After use, put the protective cap back on and dispose of in a safe manner to avoid accidental lancet stick injuries.

GLUCOCARD Vital 4:10pm 10/19 mg/dL 101 arkray

TROUBLESHOOTING

Refer to the GLUCOCARD Vital Blood Glucose Monitoring System user instruction manual for further details.

4:10pm 10/19 L0

SUUOCARO Vital 4:0pm 10:19 10:1 Arrau