Concentrator

Assembly, Installation and Operating Instructions

Model No. - For use with IRC5P and IRC5P2

SAVE THESE INSTRUCTIONS

NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact the Carrier/Invacare for further instruction.

Safety Summary

WARNING

DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions and Instructions in this instruction sheet contact your Home Healthcare Dealer before attempting to install this equipment – otherwise injury or damage may result.

DO NOT move the concentrator while the HomeFill compressor is on the ready rack. Separate the HomeFill compressor from the ready rack prior to transporting.

Children should ALWAYS be supervised around the HomeFill unit. When used with the HomeFill ready rack or similar elevated support surfaces, a child could pull over any such stand causing the unit to fall. Failure to observe this warning may result in personal injury or product damage.

Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products.

CAUTION

The HomeFill ready rack is designed for use with the Invacare Perfecto $ _{2} $ concentrator and Invacare HomeFill compressor only. DO NOT attempt to use this ready rack with other products. Otherwise, damage to the ready rack and/or the other devices may occur.

Assembly

The HomeFill ready rack requires no assembly and is provided in a ready for use condition.

For more information regarding Invacare products, parts, and services, please visit www.invacare.com

Installing the HomeFill Ready Rack

NOTE: For this procedure, refer to FIGURE 1 on page 3.

1. Position the Invacare Perfecto $ _{2} $ concentrator in the desired location.

2. Align the HomeFill ready rack above and toward the rear of the concentrator (Detail "A").

3. Move the ready rack forward until the rear pins fully engage the concentrator mounting holes (Detail "B").

4. Rotate the latch down over the handle to secure in place (Detail "B").

5. Orient and place the HomeFill compressor onto the installed ready rack as shown (Detail "C").

NOTE: The HomeFill compressor will prevent the latch from becoming unsecured.

6. Connect the HomeFill fill hose to the concentrator and compressor. Refer to Perfect $ _{2} $ owner's manual, part number 1143482, for proper connections.

Transporting

WARNING

DO NOT move the concentrator while the HomeFill compressor is on the ready rack. Separate the HomeFill compressor from the ready rack prior to transporting.

1. Disconnect the HomeFill unit from the concentrator and remove unit from the ready rack prior to transporting.

NOTE: For operating instructions of the concentrator and/or HomeFill compressor, refer to Perfecto $ _{2} $ owner's manual, part number 1143482, or HomeFill owner's manual, part number 1100873.

DETAIL "A" - ALIGNING THE READY RACK

DETAIL "B" - INSTALLING THE READY RACK

Latch Rear Pin

HomeFill Ready Rack

Rear Pin Mounting Holes

Concentrator

DETAIL "C" - POSITIONING THE HOMEFILL ON THE READY RACK