Moneual Rydis R750 User Manual

Warning

Before using the product

Remove light clothes or fragile materials from the floor.

These matters may obstruct movement of the product or cause a breakdown of the product.

Remove any obstacle from the floor in the space where the product travels about. The product can't travel the area which is blocked with an obstacle of certain height.

Do not install the product in the place under direct sunlight.

Direct sunlight may cause discoloration of the product.

Adapters may cause electric shock or fire due to overheat during charging.

Do not install the charger on an inclined floor, and do not give an impact to the charger. The charger may be damaged or broken.

Install the charger in a place that can be easily detected by the robot.

If the site is in a corner or has many obstacles around it, automatic charging is not possible.

Do not use the product in the room with a child or an elderly person who is left alone.

A child or an elderly person can be frightened or injured.

• Make sure that the power of the charger is always supplied.

Otherwise, you cannot use the function of making the robot go back to the charger for automatic charging after it finishes cleaning.

In using the product

Do not stand or sit on the product.

Movement of the product may cause an injury or the product can be damaged.

Do not use the product in a narrow and elevated place such as a desk.

The product may fell down, causing an injury to people or damage to the product.

• Make sure that no liquid enters the product.

The product may malfunction or can be damaged.

If the product happens to inhale plastic bags or others, they should be immediately removed. If the dust intake gets clogged and the product is used for a long time with the internal motor overheated, the product will be damaged.

Do not use the enclosed battery charger for charging of any other product.

The charger or other products can be damaged.

Make sure that clothes, hair, fingers or other body parts are not caught by the wheels. An injury may occur.

Do not press the bumper of the product severely or give excessive shock.

The bumper sensor can be damaged and then work abnormally.

Do not keep or use the product at too low or high temperature.

Do not use the product at the temperature of $ -5^{\circ} $C or lower or $ 35^{\circ} $C or higher.

Do not make the robot perform cleaning with the dust box filled with dust.

It can cause reduction in sucking power.

• Check if the filer is inserted into the dust box.

If the robot gets activated with no filter, it can cause product failure.

Prevent the main brush and the side brush from being clogged with hairs or other foreign substances.

It can cause noise and reduction in sucking power or damage to the product.

Before using the product, clear away stuffs from the floor and make arrangement nearby.

Small dish towels, bath towels, pads, telephone lines, power cables, strings or belts can be entangled with the operating wheels or the brushes.

Make sure to remove stuffs that can be broken (ceramic wares, glass cups, etc.).

Do not use the product in a site whose walls or floor is made of mirror or glass.

The obstacle sensor of the robot cleaner uses an infrared sensor and so it may not see glass or mirrors as obstacle.

Do not use the product in a utility room, on a wet floor, in stairs, on a table or shelf, in an underground room, a warehouse, a commercial building or the outdoors.

If you have dropped the product or caused an impact to the product, contact the designated service center immediately.

Electrical cautions

• Make sure to use the specified voltage and current.

Power supply outside the specifications ranges may cause a serious damage to the product.

The battery can be