I tore down my Macbook Pro to clean the dust off.
During the disassembly process, I didn't touch the Touch ID connector. I just removed the motherboard to replace the thermal paste and clean the fan.
After I reassembled it, everything is great, except the Touch ID was not working. But the power button is good.
Any ideas about it?
Thanks!
Questa è una buona domanda?
Rep: 495,6k
35
338
974
The TouchID cable and the connector interface at the logic board is where you need to check. The cable could have a tear severing one of the lines, at the connector a pin connection could be damaged either by being a bit hard prying it off or pressing on it without aligning it properly before pressing it on with a light touch.
Hopefully you can fix the damage which is still not easy! If you can't repair your options are only replacing the logic board as the button ID key is perm bonded to the given logic board (you can't replace it on its own).
Questa risposta è stata utile?
Ultime 24 Ore: 1
Ultimi 7 Giorni: 2
Ultimi 30 Giorni: 8
Tutti i Tempi: 94
