Rep: 23
1
The eject button labeled SW1 on the motherboard has gone limp and no longer clicks in. Is there hope of buying a replacement part and soldering it in or will I need to buy a new motherboard?
Questa è una buona domanda?
Rep: 33,2k
26
35
32
These look pretty standard as far as buttons go. I was able to find an ebay listing for just button components fairly easily.
I suspect most of the challenge would be finding the right form factor for the button, This looks like a very cut-and-dry solder job though, and not too challenging.
Questa risposta è stata utile?
Ultime 24 Ore: 0
Ultimi 7 Giorni: 1
Ultimi 30 Giorni: 4
Tutti i Tempi: 49
2 Commenti
@radicalstr13497 Can you upload pictures of the button and where/how it mounts to the circuit board?
da Andrew S
@andrewsawesome Done sorry for the poor quality
da Radical Strawberry