Aggiusta la tua roba Comunità Store

Xbox One S, progettata da Microsoft Corporation, è stata rilasciata ad agosto 2016. Xbox One S è una riprogettazione di Xbox One.

428 Domande Visualizza tutte

Opzioni

Issues with replacing HDMI port

Hello, I attempted a hdmi port replacement which I ripped out a few a pads. I however ran some jumper wires. However when connected to a tv it doesn’t display anything. When doing a continuity test pins 1,3,4,6,7,9,10,11,12, and 13 don’t seem to be grounded. Anyone know what I did wrong and how I can fix it?

Block Image

Block Image

Block Image

THE SHORTED COMPONENTS. As I stated I am unsure if they are supposed to be shorted. I don’t see a visible bridge of solder connecting them.

Block Image

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

2 Risposte

Filtra per:
Più utili Più recenti Più Vecchio
Soluzione Prescelta

Opzioni

take the port off and check the pins, if they are no longer shorted then its your soldering thats the issue, here are the readings you should be getting.

Block Image

Questa risposta è stata utile?

Sì No
Punteggio 1

1 Commento:

I ended up buying a new port. Which fixed the issue.

da

Aggiungi un commento
Risposta Più Utile

Opzioni

It looks like some pins were shorted - To be checked but if you have a multimeter you cloud to check if the pin you resolder is shorted or not...
If you look at the number "7" on the PCB, the pins 13 and 14 seams to touch.

following the tracks on the PCB I would try to test for continuity from the front of the connector to the nearest component.

Block Image

Questa risposta è stata utile?

Sì No
Punteggio 2

2 Commenti:

So I decided to desolder the whole hdmi port and solder it back. I tested the connection from the components to pins and they all seemed to have continuity. However pin 1 and pin 2 seems to be shorted. I have no clue if they are supposed to be shorted as there is no visible connection. I have attached a picture which I highlight the other component that is also shorted. Also my tv recognizes something is plugged in, but doesn’t display anything.

da

If you use flux your solder will run better.

da

Aggiungi un commento

Aggiungi la tua risposta

Emanuel sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 219