the file was in sim card and the 3d printer was shown the file but when i click on it it is no doing it imdly so i have to wait for a while or it should imdly work on it.
Questa è una buona domanda?
The printer waits till all the heated parts are up to the programmed temperature before the print starts.
Hope this helps.
Questa risposta è stata utile?
make sure you have installed the proper firmware on the motherboard via the SD card.
Don't be a muppet, get the download straight from creality.
If that doesn't work, then if you are using a 4.2.7 motherboard, make sure your UI is the new touchscreen one.
If its a 4.2.2 then you should be fine
Questa risposta è stata utile?
Ultime 24 Ore: 1
Ultimi 7 Giorni: 4
Ultimi 30 Giorni: 6
Tutti i Tempi: 33
