This is a very specific question, but I hope you can help me out.
I need to figure out what the pinnout of the PSU connector is. The unit itself can be bought, but there are no documents. Also board diagrams are impossible to find.
S/N: ADP-6BF S/ OT9031
https://de.aliexpress.com/item/100500341...
thank you for any help.
Questa è una buona domanda?
Rep: 479,7k
35
329
971
Have you just probed the board connector to measure things. You basically have two sets of wires for the positive and negative (ground) sides as well as a pair of wires for the power enable.
Using an Ohm meter you should be able to isolate the lines.
Questa risposta è stata utile?
Since the ATV doesn't se over 15 W at peak, I'm converting mine to USB C. Thx for the fast reply. I'm mostly interested in the V coming over each wire, so that I design my usb-c power distribution pcb correctly.
Ultime 24 Ore: 0
Ultimi 7 Giorni: 5
Ultimi 30 Giorni: 12
Tutti i Tempi: 78
