Rep: 25
3
1
As with many other users I have a Packtalk Bold out of warranty with a bad USB connector. It works if the cable is held pressed up or down. Many have had solder failures but not this one, I need a new connector but studying images and footprints at Mouser and DigiKey has failed to ID a likely candidate.
Questa è una buona domanda?
Rep: 43
2
you can find the correct USB connector here....warning...its a bit tricky without the right equipment. I have successfully fixed two so far with USB replacements. If the trace has pulled away from the board....you may need to fix that also. https://www.amazon.com/gp/product/B00NQB...
Questa risposta è stata utile?
Thank you I bought a couple of these off Amazon from your link from uxcell and had my local “iKrack” micro solder shop replace one for me. It worked well.
Rep: 1,2k
6
3
1
is standard micro usb, but many Times on this model is the PCB lines missing, then need make jumper.
Questa risposta è stata utile?
Rep: 300
7
1
2
There is a good Youtube video on this process: https://www.youtube.com/watch?v=FLr-Keiv...
Questa risposta è stata utile?
Ultime 24 Ore: 1
Ultimi 7 Giorni: 5
Ultimi 30 Giorni: 36
Tutti i Tempi: 1,400
6 Commenti
Did anybody ever find a solution to this problem
da Mike Brown
https://www.youtube.com/watch?v=FLr-Keiv...
da FJrider
The YouTube link shows someone doing it, not someone willing to share the P/N.
da David kelly
https://www.amazon.com/gp/product/B00NQB...
da JJ Jefferson
Meh. My question is, “what is the part number of the usb socket?” The YouTube video and poster refuses to share his secret.
da David kelly
Mostra 1 altro commento