Rep: 1
1
Hi guys,
My girlfriend's ghd hair straightners have been broken by my big clumsy boot! All inner cabling seems intact but the shell is cracked and split. However, it did not shatter and the shell fits back neatly, but it will require some sort of heat resistant/tolerant adhesive. Any ideas anybody?
Thanks
Bill
Questa è una buona domanda?
Rep: 782,4k
1,1k
893
2,3k
billzeebub, I'd go with jb weld. Available at most hardware stores as well as automotive stores.
Properties (psi)
Tensile Strength: 3960
Adhesion: 1800
Flex Strength: 7320
Tensile Lap Shear: 1040
Shrinkage: 0.0%
Resistant to: 500° F
Should do the trick :-) of course not sure if it is available in your part of the world. http://www.modelsforsale.com/catalog/pro... looks like some pretty good stuff if you are in the UK. Hope this helps, good luck.
Questa risposta è stata utile?
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 0
Tutti i Tempi: 1,560
2 Commenti
billzeebub, I am currently working on a Chi as well as a crock. Just out of curiosity, what straightener do you have :-)
da oldturkey03
ghd 4.2, not the switch arm
da billzeebub