Aggiusta la tua roba Comunità Store

L'Apple Watch Series 1 è una revisione dell'Apple Watch originale ed è stato annunciato il 7 settembre 2016. La maggior parte dei componenti è la stessa del Series 2

123 Domande Visualizza tutte

Opzioni

Touch not working after replacing screen (but screen works however)

Hello! I have a 38mm Apple Watch Series 1 where the screen was cracked at the corner and the touch wasn't working. I replaced the screen and it powers on and displays just fine, but the touch still isn't working. I even tried replaced the force touch sensor and it still doesn't work. Can anyone provide any insight please?

The watch is stuck on airplane mode, which I can't change because I can't touch the screen. The side dial and button work and I've tried to force restart it. I've also tried reseating the screen connection a few times and cleaning the contacts with a bit of isopropyl alcohol. Thank you for your help!

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

1 Risposta

Filtra per:
Più utili Più recenti Più Vecchio

Opzioni

Did you replace the touch sensor? You often need to when you take the crystal/display unit off.

Questa risposta è stata utile?

Sì No
Punteggio 0

10 Commenti:

Do you mean the force touch sensor (with the gasket)? I did replace that yesterday but the touch still didn't work

da

@playaone - Yes, how did you a fix the display the sensor needs to be compressed to work. Using the wrong adhesive is one thing I’ve seen. The other is the sensor was not connected.

da

@danj the force touch sensor came with a double-sided adhesive gasket - I stuck one side to the body of the watch and made sure it's connected.

During my testing, I did not place the small metal latch that goes on the screen connector (steps 22-24 in this guide: Sostituzione schermo Apple Watch Series 1) and did not adhere the screen so that I can test it before closing everything up. Could this have an effect on the touch not working? The display works fine and I can use the side buttons and everything

da

@playaone - the clip is needed. The extra release paper could be causing you issues as it adds an extra layer.

da

@danj I attached the clip but still no change. I may be mistaken, but isn't the touch capability tied to the screen itself? I read on this forum that the touch force sensor isn't really needed for the touch screen to work (I guess touch force is a different function - I'm not too familiar with Apple watches myself). Do you think there is something else I can do? I'm hesitant to fully adhere the touch force sensor to the screen as that would be permanent and if I want to remove the screen again I may damage the sensor.

Thank you for your help thus far

da

Mostra altri 5 commenti

Aggiungi un commento

Aggiungi la tua risposta

alphacat92 sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 16

Tutti i Tempi: 191