Salta al contenuto principale

Seconda generazione di iPhone. Modello A1241/8 o 16 GB di memoria/plastica posteriore bianca o nera. La riparazione è più semplice rispetto al primo iPhone. Richiede l'uso di cacciaviti e strumenti di leva e distacco con ventose.

1158 Domande Visualizza tutte

Home button not working after dissassemble

Hello I recently dissassembled my iPhone to change the volume button and after re-assembly the Home Button stopped working.

I already checked the gold prongs on the back, and made sure that the dock connector was properly assembled. But still not working....any ideas ?

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Punteggio -1
Aggiungi un commento

2 Risposte

Soluzione Prescelta

On the logic board, under where the Home button is, you'll find the home button flex cable. You might check that the button on the flex cable is working, if not, you may need to replace it. I use a jewelers 30x loupe to check the cables for any slight tears.

Block Image

Questa risposta è stata utile?

Punteggio 6

6 Commenti:

Check the Home Button Flex for continuity with a volt meter when you push the Home Button. Also for the Home Button to work, Flex Cable #4 (the dock connector Flex Cable) must be seated correctly to the Logic Board.

da

+ love the pic you've added here John.. Gustavo, is this the same problem as your other question? If so it helps to keep just to asking once...we'll keep troubleshooting both otherwise and give the same advice again. if the above tips don't work then you may need a new dock connector :-(

da

Going to try a new dock connector, thank you. And yes pollytintop sry :(

da

John, if you intent to keep giving good answers, please fill out some on your profile so we can get to know you ;-) Thanks

da

@Gustavo - Glad you got it nailed down Gustavo. Good luck on your repair and if you have any questions there are always many fine members here that are more than willing to lend some sound advice.

da

Mostra 1 altro commento

Aggiungi un commento

Good way to check whether dock connector or not is to simply jump the contact pads with a screwdriver. If you get the same result as if you had pressed the button. then your problem is in the flex.

Another common mistake I've seen people make during screen repairs is simply pressing the prongs down during screen removal. Since it's not outright damaged it often gets overlooked, but if they are compressed they will not be making a connection.

Questa risposta è stata utile?

Punteggio 1
Aggiungi un commento

Aggiungi la tua risposta

Gustavo Camacho sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,398