Aggiusta la tua roba Comunità Store

Modello A1311 / Metà 2011 / Processore Core i5 da 2,5 e 2,7 GHz o Core i7 da 2,8 GHz

432 Domande Visualizza tutte

Opzioni

Black Screen after changing thermal paste

IMAC 2011 21.5 EMC 2428

It was working perfectly.  It was opened to change thermal paste.  Now it turns on but the screen goes black after a few seconds the fans accelerate.  

The diagnostic LEDs light up the 4.

 Apparently there was no error in the assembly or damage to any cable or board.

 the machine had no problem with the video card before

 After reassembly, he presents this symptom.

 Only the thermal paste of the processor was changed.

The video card has not been tampered with.

 Do you have any tips or details that I may be missing?

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

1 Risposta

Filtra per:
Più utili Più recenti Più Vecchio
Risposta Più Utile

Opzioni

More often than not, you likely didn’t mount the CPU correctly. You’ll need to pop is off again to make sure the socket pins are not damaged and when you remount the heat sink make sure you slowly tighten the screws in a cross pattern like you do for changing a tire rim, tighten each screw in a star, or criss cross, pattern.

Questa risposta è stata utile?

Sì No
Punteggio 2

2 Commenti:

the screws on this heatsink seem to be wrong, they don't seem to want to screw in the normal way. Before reading your comment, I took apart everything and retained the heatsink screws again, this time without tightening them too much. I reassembled everything and it worked again.

da

@friedericham - If you're set don't forget to accept the answer - Thanks!

da

Aggiungi un commento

Aggiungi la tua risposta

friederich.maiochi sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 9

Tutti i Tempi: 269