2 broken pins in u3400
I was replacing U3400 and i have a 2 broken pins on the board, any ideas how to fix it?
Questa è una buona domanda?
Punteggio
0
680205
1 Risposta
Risposta Più Utile
Rep: 50,7k
8
14
101
If they are the blue pads you can leave them off as they are not connected to anything. If they are other pads you will need to carefully scrape down to the trace and make a pad with some jumper wire.
Questa risposta è stata utile?
Punteggio
2
2 Commenti
What pads came off? There are 9 NC pads so it could be one of those.
da Chris Stables
@imicrosoldering actually i dont have the schematic to tell you which pads, but there is 3 pins in the middle of the board are broke, i just need an advice of how to take it back if there is anyway
da Mahmoud Baroudi