Salta al contenuto principale

Modello metà 2010, A1278 / processore Core Duo 2,4 o 2,66 GHz

Locating a Damaged SMD Component

Hi

Im repairing my a1278 logicboard due to water damaged. Ive found out that the airport card and bluetooth card module were not working. Ive replaced both and only the bluetooth works.

The laptop works ok except keyboard backlight, ethernet port and airport. If I can locate what's the name of this IC, on picture below, I can go futher. I do have a schematic manual of the a1278 but I'm trying to get used to it. See picture:

Block Image

I have all the tools to repair liquid spills but this IC I need to replace. Ive tried a digital camera but the number is not clear.

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio -1
1 Commento

How did you get ahold of a schematic manual? can you point me in the right direction?

da

Aggiungi un commento

2 Risposte

Risposta Più Utile

I have one here that says LDPR on the top line and underneath it says 060I.

I recommend using a heat pump to replace this chip. I hope you have flux as well. You might need to bring the temperature up to 350C to get the component off.

Questa risposta è stata utile?

Punteggio 1
Aggiungi un commento

my problem is in the same area. however the chip below it may be the culprit as it gets hot! ive also noticed in place of where you are pointing in the picture the component below is a small black resistor where my board has a fat silver rectangle with black on top and some writing that is burnt off. could the ic you are replacing have anything to do with that chip getting to hot?

i need to know what this chip is and if i can buy it somewhere to replace.

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

Aggiungi la tua risposta

Daveyon sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 6

Tutti i Tempi: 1,059