Aggiusta la tua roba Comunità Store

High-end multimedia laptop by Asus.

9 Domande Visualizza tutte

Opzioni

cpu block screw nut disconnected from N551W motherboard

My laptop had an accident lately and its CPU start to heat up so fast so I opened it and saw that two of CPU block nuts disconnected from motherboard. I resolderd them but they disconnected again. I tried to resolder them for 4 or 5 times but again they disconnect so quickly. How can I make them to stay in their places and not to fall out? Is there any special adhesive use for this purposed?

Block Image

both shown nuts are disconnected, blue one was resolderd when I took the photo but disconnect in les than half an hour

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 1
Aggiungi un commento

1 Risposta

Filtra per:
Più utili Più recenti Più Vecchio
Risposta Più Utile

Opzioni

It’s a bit fiddly, but finding the right size screw/nut&bold is better than any glue. You want to give it something to latch onto from the under side. This is that way I normally do it for long term results when the proprietary fitting is beyond repair. The issue your going to have with glue is both pressure and heat.

Questa risposta è stata utile?

Sì No
Punteggio 1

1 Commento:

I was thinking about adding longer screw and nut at the back of pcb but i have some serious issues founding some right size nuts. My laptop has fan problem too ( magnetic levitation not working) and i couldn't find any replacement for it and I can't import because it will cost so much and I afraid this will happen again for nuts.

I should look at electronic dumpster.

Thanks for the answer

Best regards

da

Aggiungi un commento

Aggiungi la tua risposta

Matin sadroddin sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 130