I just recently replaced the back glass for my S8 because the old one was cracked. However, the new glass isn't fully adhering to the frame. After applying pressure, a small gap remains on the long sides between the back glass and the phone. How can I make sure the back glass fully sticks?
Questa è una buona domanda?
Rep: 2,4k
6
1
1
did you cleaned and replaced the adhesive too?
Questa risposta è stata utile?
Yes, I cleaned off the previous adhesive and then used a new one.
Is your battery flat? a expanded battery can push out your glass, also a
bent housing can affect.
The battery was flat and the housing was also flat.
Rep: 167
4
2
1
It could be low quality adhesive. I recommend using 3mm adhesive, not the premade stuff. I also recommend to put a soft rag over the phone and leave about 10 to 15 pounds of weight on top of the phone for about 2 hours. I use 3 five pound weights that were previously used for dumbells. Hope this helps.
Questa risposta è stata utile?
Ultime 24 Ore: 1
Ultimi 7 Giorni: 1
Ultimi 30 Giorni: 4
Tutti i Tempi: 324
