Salta al contenuto principale

Released September 2015, the JBL Xtreme is a portable, Bluetooth speaker that is also splash proof.

69 Domande Visualizza tutte

Replacing BMS board and batteries

Hi everyone,

I changed the battery in my JBL Xtreme half a year ago: [SOLVED] Horrible sound after battery replacement.

The speaker was working perfectly up until now, it seems to be very inconcistent with charging. When I opened it up I saw the whole BMS board was oxidized. (From using too much flux)

Update (06/21/2018)

There's a video about this by Abrar Akram that explains it in more detail: LINK

These are 2 compatible boards that can be found on Aliexpress that are very cheap 'HX-2S-D01' and 'HX-2S-A10'

I made a diagram for the wiring, 2 sources confirmed this to be correct.

Block Image

I will post pictures of the result.

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

Batterie per PC portatili

Una soluzione semplice per un grande aumento di potenza.

Acquista ora

Batterie per PC portatili

Una soluzione semplice per un grande aumento di potenza.

Acquista ora

2 Risposte

I used the same connection but the batteries are not charging. I am using 2600 mAh batteries and not 3400 mAh ones thats shown in your example. Do i need a different BMS?

Questa risposta è stata utile?

Punteggio 0

Commenti:

Did you let the BMS board cool down? It's a safety mechanism that it doesn't charge when hot. Also read the voltages on the pads maybe the wiring is bad.

da

I found that one of the parallel battery set was fried. I mistakenly used a 100 ohms resister. I have got new batteries and trying again with 10K resister, it shows charging and all good as i am typng this response.

da

Just curious, how did you find out the batteries were fried?

I tried to replace the original battery with 4 18650's and a new BMS (HX-2S-A10) but no luck.... The speaker says it's charging (one blinking white led). If disconnected, it remains on for a couple of seconds (red led blinking) and shuts itself down.

The batteries (2x2 parallel) read 3,45v each, so that seems to be fine. Not sure why the batteries are not charging.

Any thoughts?

da

Aggiungi un commento

So, does it work? Putting a 10K resistor in that BMS? I have a jbl xtreme with the battery problem, i mean, battery is gone already, so i do have the 18650 packs but i think that the original BMS is dead.. Wondering to buy this one and try…

Questa risposta è stata utile?

Punteggio 0

Commenti:

It worked for me. The reason mine wasn't charging before was because I accidentally used the wrong resistor (thinking it was 10K)

da

Aggiungi un commento

Aggiungi la tua risposta

Dennis De Wolf sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 33

Ultimi 30 Giorni: 180

Tutti i Tempi: 1,274