Aggiusta la tua roba Comunità Store

Introdotto il 19 settembre 2014, questo iPhone con schermo da 4,7" è la versione più piccola dell'iPhone 6 Plus. Identificato dai numeri modello A1549, A1586, and A1589.

4994 Domande Visualizza tutte

Opzioni

Reduced cellular signal after replacing lightning connector

I followed the step-by-step instructions on replacing the lightning connector (iPhone 6). Had the usual difficulty reconnecting the antenna wire, but managed it. Now the level of cellular signal is significantly reduced with the phone having difficulty holding onto (Verizon) LTE, often dropping back to 3G. Also, the battery life is reduced, presumably because the radio is working harder.

Any suggestions ?

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

3 Risposte

Filtra per:
Più utili Più recenti Più Vecchio
Soluzione Prescelta

Opzioni

Can be a faulty part.

Put back the old one and test the signal - see if the signal improves. If it does, request a replacement from iFixit.

Provided of course that you did not damage round antenna socket near the battery connector, or the antenna cable itself that plugs into that socket.

Questa risposta è stata utile?

Sì No
Punteggio 2
Aggiungi un commento

Opzioni

One of the antennas is built into the charging connector make sure its a good part and also make sure its plugged in correctly its the small circular connector next to the battery :)

Questa risposta è stata utile?

Sì No
Punteggio 0

1 Commento:

As mentioned, I think the antenna connector is secured. I hope the part is good - it was from iFixit

da

Aggiungi un commento

Opzioni

Always rule out parts first it can always be faulty or damaged during installation check everything is connected and the screws are in I'm sure there's one screw that goes into the chassis that has to be in securely in the corner, I haven't got a 6 with me at the moment. If everything is all in and it was working before and that's the only change made then rule out the part by trying another one or replace the little wire from the old connector to the new one (needs to be soldered)

Questa risposta è stata utile?

Sì No
Punteggio 0
Aggiungi un commento

Aggiungi la tua risposta

adrian sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 4

Tutti i Tempi: 80