Salta al contenuto principale

Nel 2012, Sony annunciò che la società avrebbe rilasciato una nuova versione della sua console PlayStation 3 del 2006. La nuova console fu chiamata PlayStation 3 Super Slim ed è identificata dal numero di modello CECH-4000. La PlayStation 3 Super Slim (CECH400x) è la terza versione della console per videogiochi PS3 prodotta da Sony Computer Entertainment. Fu lanciata sul mercato il 25 Ottobre 2012.

211 Domande Visualizza tutte
Domanda Chiusa

HDMI Port replacement for ps3 super slim

hello , my HDMI port out broken in my ps3 super slim i'm asking if it's the same other HDMI ports like TV cuz i'm gona try replace it and worry it's it's specific part

regards

Block Image

Block Image

Update

THESE ARE THE PHOTOS ,HOPE THEY CLEAR FOR YOU

Block Image

Block Image

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

2 Risposte

Soluzione Prescelta

Serag Zwait, most likely not. There are even two different types of HDMI port used for the super slim. The only way to determine this is by physically looking at the ports and to compare them.

Questa risposta è stata utile?

Punteggio 2

5 Commenti:

thanks , i'm try to find replacement port to change , maybe got it new or used from broken tv

da

Not sure where you are located but you should be able to obtain a port that will definitely fit with relative ease. Post an image of the port so we can identify it as model A or B

da

ok i will check it and back to you and post photos ,

da

please check the comment bellow i attached picture with HDMI port of my PS3

da

Looks like a type B HDMI take another picture of the top part, just to make sure. Very, very unlikely that the one from your TV fits. If you have a pair of vernier calipers you can measure the pins and compare it with the one you have.

da

Aggiungi un commento

Since the replacement HDMI replacement female units are so inexpensive and yes it could be used in a number of products. If you are planning on returning soldering it back in. I would use a heat gun waving it back and forth over and over until the holes are all revealed and it will either fit in or not. Just use thick aluminum foil and insulate any rubber plastic ect. Also the four largest solider points just support the actual unit. That is the only worry I have since I am doing the same thing as you right now.

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 4,470