Salta al contenuto principale

Quinta generazione dell'iPhone. La riparazione di questo dispositivo è semplice e richiede cacciaviti, strumenti di apertura e pazienza. Nero o bianco, GSM/CDMA / 16, 32, o 64 GB.

2193 Domande Visualizza tutte
Domanda Chiusa

Why do I keep blowing LCDs?

Phone mowed over with a lawnmower. the only thing salvageable was logic board and loudspeaker. replaced EVERYTHING else including midframe. I put new digi assembly in and it works great for a little while, then i pick it up to check it and the LCD has no pic, green in color, horizontal lines all the way down the screen, and LCD flashes. replaced digi assembly twice now. digi doing same thing on test phone. any idea what issue could be? is this phone fixable? when the phone works it works great, everything in the phone functions when it should. only after time does this happen

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
1 Commento

and test phone... is this another iphone that is functional or the same barely-made-it phone...?

da

Aggiungi un commento

1 Risposta

Risposta Più Utile

i think there could be damage at the connector or logic board... is the phone really hot when this happens...? Overheating can mess with the display also but that signals a logic board issue... personally dont think its the lcd if the display is good at different times... usually pixelized, blinking out lcd hints a loose connection because if the lcd was bad you would not be getting a clear display at one time and bad display at another point in time, when a part is defective the problem is consistent... i say either connector or one of the ic's on the logic board... especially if there is heating...

but dont get it twisted overheating can mean also the processor is working harder than usual... or the camera integration on the logic board is commonly known to cause some heating...

Questa risposta è stata utile?

Punteggio 1

1 Commento:

The phone is not getting hot at all. it really does act completely normal when LCD works. The LCD does not pixelate at all as there is no picture at all. the screen is just pale green with horizontal lines and the screen flashes. looked at connector in the microscope and i do not see any damage. Is there a way to troubleshoot this?

da

Aggiungi un commento
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 112