Salta al contenuto principale

13" aluminum unibody, 2.0 or 2.4 GHz Core 2 Duo processor.

574 Domande Visualizza tutte

Is another MagSafe DC-In Board compatible with this MacBook?

I need this: MacBook Unibody (A1278) MagSafe DC-In Board

But I have access to a used one of these: [prodotto collegato mancante o disabilitato: IF161-037]

How similar are they? Can I replace the 820-2361-02 with a 820-2565-A?

Immagine MacBook Unibody (A1278) MagSafe DC-In Board

Prodotto

MacBook Unibody (A1278) MagSafe DC-In Board

$19.99

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

4 Risposte

Risposta Più Utile

I know this is an old issue, but I had the same scenario just occur: I had an 820-2361-A (identical to the 820-2361-02) that I wanted to replace with an 820-2565-A.

I did find as well that one of the screw-holes did not line up, but the other did. I tightened that one as best as I could by hand, crossed my fingers and plugged it in. Sure enough it seems to be working fine!

Questa risposta è stata utile?

Punteggio 1
Aggiungi un commento

This 820-2565-A is compatible with A1278 mid 2010 late 2010 & early 2011.

Good luck

Questa risposta è stata utile?

Punteggio 0

2 Commenti:

it worked electrically, but the screw holes did not match. Turns out I have a separate problem.

da

Best to get the correct part as the MagSafe connection is not reliable as it will shift!

da

Aggiungi un commento

Just another data point. My:

17" Unibody MacBookPro8,3 Early 2011, Model A1297

requires the DC-IN board: 820-2361-A

Amazon sent the 'Power Jack Board 820-2565-A' by mistake. The second hole is off by about 2mm, and thus not possible to secure with the second screw. Chip and layout looked identical (but no way to know). Under deadline pressure, I proceeded with the install. Fixed and booted. So far so good. At first was concerned about DC-IN board rotating, but the pull of the magnetic connector does not apply inward pressure to the board.

Questa risposta è stata utile?

Punteggio 0

1 Commento:

I had the same issue. I tightened the screw closest to the corner and then in the process of trying to tighten the screw that is off by 2mm I snapped the sheath that attaches to the back of the board. Without the sheath the screw actually has enough room to attach.

Problem accidentally solved!

da

Aggiungi un commento

I did something similar, but used the connector like a guide …. was easier! Just one screw !

Block Image

Questa risposta è stata utile?

Punteggio 0

2 Commenti:

Sorry, this is not wise! The second screw stabilizes the connection. Best to get the correct part.

da

You are ABSOLUTELY right !

Till I get the right part works .

da

Aggiungi un commento

Aggiungi la tua risposta

Chris Thompson sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 6

Tutti i Tempi: 3,209