Salta al contenuto principale
Aiuto

Versione corrente di: jayeff

Testo:

Hi @daniel35428
-Assuming that you didn't do this when cleaning the fans but try lubricating them and check if that resolves the problem.
+Assuming that you didn't do this when cleaning the fans, try lubricating their bearings and check if that resolves the problem.
Usually with most DC fans if you gently peel off the fan maker's label in the centre of the fan you may find a rubber seal that is covering the bearing.
Gently remove the seal and apply ''1 drop (only)'' of a light grade machine oil (sewing machine oil perhaps) onto the bearing and then reseal it and replace the label (if possible or cover it if the label won't re-stick).
Worth a try.

Stato:

open

Modifica di: jayeff

Testo:

Hi @daniel35428
Assuming that you didn't do this when cleaning the fans but try lubricating them and check if that resolves the problem.
-Usually with most DC fans if you gently remove the fan maker's label in the centre of the fan you may find a rubber seal that is covering the bearing.
+Usually with most DC fans if you gently peel off the fan maker's label in the centre of the fan you may find a rubber seal that is covering the bearing.
Gently remove the seal and apply ''1 drop (only)'' of a light grade machine oil (sewing machine oil perhaps) onto the bearing and then reseal it and replace the label (if possible or cover it if the label won't re-stick).
Worth a try.

Stato:

open

Modifica di: jayeff

Testo:

Hi @daniel35428
Assuming that you didn't do this when cleaning the fans but try lubricating them and check if that resolves the problem.
-Usually with most DC fans if you gently remove the fan makers' label in the centre of the fan you may find a rubber seal that is covering the bearing.
+Usually with most DC fans if you gently remove the fan maker's label in the centre of the fan you may find a rubber seal that is covering the bearing.
Gently remove the seal and apply ''1 drop (only)'' of a light grade machine oil (sewing machine oil perhaps) onto the bearing and then reseal it and replace the label (if possible or cover it if the label won't re-stick).
Worth a try.

Stato:

open

Post originale di: jayeff

Testo:

Hi @daniel35428

Assuming that you didn't do this when cleaning the fans but try lubricating them and check if that resolves the problem.

Usually with most DC fans if you gently remove the fan makers' label in the centre of the fan you may find a rubber seal that is covering the bearing.

Gently remove the seal and apply ''1 drop (only)'' of a light grade machine oil (sewing machine oil perhaps) onto the bearing and then reseal it and replace the label (if possible or cover it if the label won't re-stick).

Worth a try.

Stato:

open