Versione corrente di: markparnell1972

Titolo:

Is it safe to ultrasonic barometer

Testo:

Hi , i have a hubsan H107D+ , which is flying erratically  , i taken it apart and it looks like the previous owner had tried to oil the motors or something  !! , there are 2 boards,   a PCBA receiver  board and  a 5.8 GHZ TX camera module which seem to be covered in a fine oil  !! infact theres oil all over it inside .

I would like to put the boards through my ultrasonic cleaner  but the PCBA board has a barometer on it (see photo)

[image|1471213]

[https://www.dropbox.com/s/g2o8u3qsd2bffwq/barometer.jpg?dl=0|Barometer Chip]

Is it a big no no to run a barometer through a cleaner ?

Dispositivo:

Hubsan X4 107L

Stato:

open

Risposta Accettata:

Modifica di: Dan

Titolo:

Is it safe to ultrasonic barometer

Testo:

Dispositivo:

Hubsan X4 107L

Stato:

open

Post originale di: markparnell1972

Titolo:

Is it safe to ultrasonic barometer

Testo:

Hi , i have a hubsan H107D+ , which is flying erratically  , i taken it apart and it looks like the previous owner had tried to oil the motors or something  !! , there are 2 boards,   a PCBA receiver  board and  a 5.8 GHZ TX camera module which seem to be covered in a fine oil  !! infact theres oil all over it inside .

I would like to put the boards through my ultrasonic cleaner  but the PCBA board has a barometer on it (see photo)   [https://www.dropbox.com/s/g2o8u3qsd2bffwq/barometer.jpg?dl=0|barometer]

is it a big no no to run a barometer through a cleaner ?

Dispositivo:

Hubsan X4 107L

Stato:

open