Introduzione

Use this guide to replace a blown-out microphone.

  • Before proceeding, close your computer and lay it on a soft surface top-side down.

  • Remove the following ten screws:

    • Two 9 mm 5-point Pentalobe screws

    • Eight 2.6 mm 5-point Pentalobe screws

  • The special screwdriver needed to remove the eight 5-point Pentalobe screws can be found here.

Aggiungi Commento

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
  • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

  • Remove the lower case and set it aside.

Aggiungi Commento

Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.
  • Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.

  • Do not lift upward on the connector as you disconnect it.

Aggiungi Commento

Remove the following five screws securing the battery to the upper case:
  • Remove the following five screws securing the battery to the upper case:

    • Three 6.3 mm T5 Torx screws

    • Two 2.4 mm T5 Torx screws

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.
  • When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

Aggiungi Commento

Use the flat end of a spudger to pry the left speaker cable connector up and out of its socket on the I/O board. Pry up from beneath the wires.
  • Use the flat end of a spudger to pry the left speaker cable connector up and out of its socket on the I/O board.

  • Pry up from beneath the wires.

Aggiungi Commento

Use the flat end of a spudger to pry the microphone cable connector up and out of its socket on the I/O board.
  • Use the flat end of a spudger to pry the microphone cable connector up and out of its socket on the I/O board.

  • Pry up from beneath the wires.

Aggiungi Commento

Remove the single 2.7 mm T5 Torx screw securing the left speaker to the upper case.
  • Remove the single 2.7 mm T5 Torx screw securing the left speaker to the upper case.

Aggiungi Commento

Use the flat end of a spudger to pry the left speaker off the adhesive securing it to the upper case. Remove the left speaker from the upper case. Remove the left speaker from the upper case.
  • Use the flat end of a spudger to pry the left speaker off the adhesive securing it to the upper case.

  • Remove the left speaker from the upper case.

Aggiungi Commento

Use the tip of a spudger to pry the microphone off the adhesive securing it to the left side of the upper case. Remove the microphone from the upper case.
  • Use the tip of a spudger to pry the microphone off the adhesive securing it to the left side of the upper case.

  • Remove the microphone from the upper case.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 14

Tutti i Tempi: 4,951