Introduzione

In this guide we will go over removing the top casing.

Parti

Nessuna parte richiesta.

Power down and unplug the device.
  • Power down and unplug the device.

Aggiungi Commento

Remove the antennas from the back of the device. To do this, follow steps 1 and 2 of      Installing the Antennas Guide: Linksys WAP54g Antennas Replacement

Aggiungi Commento

Remove the two black rubber feet of the device using the screwdriver. The feet are located on the bottom towards the front.
  • Remove the two black rubber feet of the device using the screwdriver. The feet are located on the bottom towards the front.

Aggiungi Commento

Once the feet are removed, two small screws will be visible. With a small screwdriver, unscrew them. Screws are phillips head, 4.35 mm in diameter, 7.88 mm in length.
  • Once the feet are removed, two small screws will be visible. With a small screwdriver, unscrew them. Screws are phillips head, 4.35 mm in diameter, 7.88 mm in length.

Aggiungi Commento

To remove the front blue panel, grip firmly and place thumbs in the two notches on top. Push thumbs forward while keeping a firm grip on bottom.
  • To remove the front blue panel, grip firmly and place thumbs in the two notches on top. Push thumbs forward while keeping a firm grip on bottom.

  • This may require a bit of force.

Aggiungi Commento

Now slide the bottom panel forward and remove it so the top casing is isolated from the bottom casing and motherboard.
  • Now slide the bottom panel forward and remove it so the top casing is isolated from the bottom casing and motherboard.

Aggiungi Commento

Unscrew the nut on the outer side of the back casing. Remove the nut and the washer from both antenna mounts. Unscrew the nut on the outer side of the back casing. Remove the nut and the washer from both antenna mounts.
  • Unscrew the nut on the outer side of the back casing. Remove the nut and the washer from both antenna mounts.

Aggiungi Commento

From here, remove the wires and nuts connected to the back panel by pulling the nuts through the holes. Now the top casing has been removed and isolated from the rest of the device. From here, you can make repairs to the top casing.
  • From here, remove the wires and nuts connected to the back panel by pulling the nuts through the holes.

  • Now the top casing has been removed and isolated from the rest of the device. From here, you can make repairs to the top casing.

  • Once the top panel is removed the main board will still be attached to the bottom panel.

Aggiungi Commento

Conclusione

From here you can take apart the rest of the router apart by following subsequent guides.

Derek Myers

Membro da: 04/10/2011

243 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 21-21, Maness Fall 2011 Membro di Cal Poly, Team 21-21, Maness Fall 2011

CPSU-MANESS-F11S21G21

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,236