Salta al contenuto principale

Sostituzione scheda UI Teenage Engineering OP-1

Inglese
Italiano

Traduzione in corso passo 4

Passo 4
Teenage Engineering OP-1 UI Board Replacement: passo 0, immagine 1 di 3 Teenage Engineering OP-1 UI Board Replacement: passo 0, immagine 2 di 3 Teenage Engineering OP-1 UI Board Replacement: passo 0, immagine 3 di 3
  • Now the UI board is free to take out. You can grab it by the knobs and start lifting it on the right side half way out.

  • On the left side the speaker and its cable might be in the way to get it out straight. Just move it diagonally to the right to get it out completely.

  • Make sure the black plastic mat underneath the UI board stays inside.

  • After reassembling you want to check the board with the internal test function. You can enter it by holding the "COM" button while powering on, then choose the function test (0).

Ora la scheda UI è libera e può essere estratta. Puoi afferrarla per le manopole iniziare a sollevarla parzialmente dal lato destro.

Sul lato sinistro, l'altoparlante suo cavo potrebbero interferire se cerchi di tirare la scheda direttamente verso l'alto. Ti basterà spostarla diagonalmente verso destra per poterla estrarre completamente.

Accertati che il cuscinetto di plastica nera sotto la scheda UI resti al suo posto.

Dopo il rimontaggio, puoi controllare la scheda con la funzione interna di test. Puoi accedere a questa modalità tenendo premuto il pulsante "COM" mentre accendi il dispositivo, e poi scegliendo la funzione test (0).

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.