Salta al contenuto principale

Sostituzione ventola MacBook Pro Unibody 13" inizio 2011

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 1

Passo 1
MacBook Pro 13" Unibody Early 2011 Fan Replacement: passo 0, immagine 1 di 3 MacBook Pro 13" Unibody Early 2011 Fan Replacement: passo 0, immagine 2 di 3 MacBook Pro 13" Unibody Early 2011 Fan Replacement: passo 0, immagine 3 di 3
  • Use the edge of a spudger to gently pry the fan connector up and out of its socket on the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

Usa il bordo di uno spudger per scollegare il connettore della ventola dalla sua presa sollevandolo dalla scheda madre.

Può essere utile ruotare lo spudger da sotto il cavo della ventola per scollegare il connettore.

La presa e il connettore della ventola sono mostrati nella seconda e terza immagine. Stai attento a non rompere la presa in plastica sulla scheda madre mentre fai leva con lo spudger per scollegare il connettore. La disposizione della scheda madre nella seconda immagine può essere leggermente diversa per il tuo dispositivo, ma la presa è identica.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.