Salta al contenuto principale

iPad Air 2 Wi-Fi フロントパネル取り外し

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 5

Passo 5
iPad Air 2 Wi-Fi  Opening Procedure: passo 0, immagine 1 di 3 iPad Air 2 Wi-Fi  Opening Procedure: passo 0, immagine 2 di 3 iPad Air 2 Wi-Fi  Opening Procedure: passo 0, immagine 3 di 3
  • Push the blue handle away from the hinge to engage opening mode.

  • Turn the handle clockwise until you see the cups start to stretch.

  • Make sure the suction cups remain aligned to each other. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn.

  • Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

青いハンドルを手前に引くと、アームがロックされます。

ハンドルを時計回りに360度回転させ、カップが両側をストレッチするまで回し続けます。

吸盤の位置が合っていることを確認してください。装着位置がずれ始めたら、吸盤を少し緩めてアームを装着し直してください。

1分ほど待つと、粘着剤が剥がれ、隙間ができます。

クランプで十分な隙間が作れたら、スクリーンのプラスチックベゼルの下にオープニングピックを挿入します。

クランプで十分な隙間が作れない場合は、さらに接着面に熱を当てて、クランプを1/4程度時計回りに回してください。

一回ごとの作業で1/4以上回さないでください。クランプをまわしたら1分間待ってください。リバースクランプの効果を待ってから、作業を続けてください。

次の2つの手順はスキップします。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.