Aggiusta le tue cose Community Store

Sostituzione gruppo pannello anteriore iPad Mini CDMA

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 5le guide che includono questo passo.

Torna alla Guida
Inglese
Italiano
Passo precedente Passo successivo

Traduzione in corso passo 2

Passo 2
iPad Mini CDMA Front Panel Assembly Replacement, Front panel preparation: passo 0, immagine 1 di 2 iPad Mini CDMA Front Panel Assembly Replacement, Front panel preparation: passo 0, immagine 2 di 2
Front panel preparation

  • This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.

  • If you're installing a new front panel assembly, it may need the following preparation:

  • Peel the large clear plastic liner off of the inside of the glass.

  • Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.

  • Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.

  • Don't remove any copper coverings from the outlined region, such as yellow kapton tape or black electrical tape.

  • Ensure the glass panel is free of fingerprints and grime before installing it on your device.

Inserisci qui la traduzione

Se stai installando un nuovo gruppo del pannello anteriore, potresti dover fare i seeguenti preparativi:

Rimuovi le coperture in plastica dell'adesivo attorno al perimetro del gruppo del pannello anteriore.

Rimuovi il piccolo pezzo di adesivo protettivo dal cavo del digitizer.

Assicurati che tutto il rame sia coperto sul nuovo schermo di ricambio, altrimenti, una volta installato in questo modo, potrebbe muoversi in modo casuale.

-[* icon_note] If you're installing a new front panel assembly, it may need the following preparation:
- [* red] Peel the plastic strips covering the adhesive around the perimeter of the front panel assembly.
- [* orange] Remove the small piece of adhesive backing from the digitizer cable.
-[* black] Make sure all copper is covered on the new replacement screen as once fitted without this the screen will move randomly.
+[title] Front panel preparation
+[* icon_reminder] This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.
+[* icon_note] If you're installing a new front panel assembly, it ***may*** need the following preparation:
+ [* red] Peel the large clear plastic liner off of the inside of the glass.
+ [* orange] Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.
+ [* icon_caution] Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.
+ [* yellow] ***Don't remove any copper coverings from the outlined region***, such as yellow kapton tape or black electrical tape.
+[* black] Ensure the glass panel is free of fingerprints and grime before installing it on your device.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.