Aggiusta le tue cose Community Store

Kobo Libra Colour 電源ボタンボードの交換

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Torna alla Guida
Inglese
Giapponese
Passo precedente Passo successivo

Traduzione in corso passo 9

Passo 9
Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: passo 0, immagine 1 di 3 Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: passo 0, immagine 2 di 3 Kobo Libra Colour Power Button Board Replacement, Disconnect the interconnect cable: passo 0, immagine 3 di 3
Disconnect the interconnect cable

  • Use the tip of a spudger to lift up the locking tab on the ZIF connector.

  • Use tweezers, or your fingers, to grip the blue pull tab on the interconnect cable and disconnect it.

  • During reassembly:

  • Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector.

相互接続ケーブルの接続を外す

スパッジャーの先端を使って、ZIFコネクタの固定タブを持ち上げます。

ピンセットか指を使って、相互接続ケーブルの青いプルタブをつかみ、外します。

再組み立ての際

ケーブルと ZIFコネクタの端に、接続状態を妨げるコ ーティングが残っていないか点検してください。

コーティングがもろくなりすぎたら、ケーブルとZIFコネクターを加熱しながら、コーティングをはがします。

見た目がきれいである必要はありません！ケーブルがコネクターにきちんと収まるように、十分な量のコーティングを剥がせばよいのです。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.