Salta al contenuto principale

Sostituzione Memoria RAM dell'iMac Intel EMC 2546 da 27"

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 4

Passo 4
iMac Intel 27" EMC 2546 RAM Replacement, Remove the RAM: passo 0, immagine 1 di 3 iMac Intel 27" EMC 2546 RAM Replacement, Remove the RAM: passo 0, immagine 2 di 3 iMac Intel 27" EMC 2546 RAM Replacement, Remove the RAM: passo 0, immagine 3 di 3
Remove the RAM
  • Remove a stick of RAM by grabbing it with two hands and pulling straight out of the RAM tray.

  • RAM modules are keyed so that they can only be installed in the proper orientation. Note where the shorter section of contacts is when removing, and reinstalling, your RAM.

  • To install a new module, insert the module into the desired slot in the tray and press it firmly in place. Push the tray back up until it locks in place.

  • The RAM access door is not symmetrical. If it is not flush on both ends, try putting it in the other way.

  • Re-insert the RAM access door back into its place.

Rimuovere un modulo RAM prendendolo con due mani ed estraendolo dal relativo alloggiamento.

I moduli RAM sono sagomati per essere installati solo nell'orientamento corretto. Notare che la sezione più corta dei contatti deve trovarsi a sinistra durante l'installazione dei nuovi moduli.

Per installare un nuovo modulo, inserirlo nello slot desiderato dell'alloggiamento e premerlo saldamente in posizione. Premere nuovamente l'alloggiamento finché non si blocca in posizione.

Lo sportello di accesso alla RAM non è simmetrico. Se non è a filo su entrambe le estremità, prova a inserirlo nell'altro verso.

Rimetti al suo posto lo sportello di accesso alla RAM.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.