Salta al contenuto principale

Procedimento di Apertura (1° e 2° generazione)

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 5

Passo 5
Opening Procedure (1st and 2nd Gen): passo 0, immagine 1 di 2 Opening Procedure (1st and 2nd Gen): passo 0, immagine 2 di 2
  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • If your screen isn't getting hot enough, you can use a hair dryer to heat along the right edge of the iPad.

  • For complete instructions on how to use a hair dryer, check out this guide.

  • Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn.

  • Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next step.

Aspetta un minuto per dare all'adesivo la possibilità di rilasciarsi e formare un'apertura.

Se il tuo schermo non diventa abbastanza caldo, puoi usare un asciugacapelli per riscaldare il bordo destro dell'iPad.

Per le complete istruzioni riguardo all'uso dell'asciugacapelli, dai un'occhiata a questa guida.

Inserisci un plettro di apertura sotto lo schermo nel momento in cui l'Anti-Clamp creerà un'apertura grande abbastanza.

Se l'Anti-Clamp non crea un'apertura sufficientemente grande, applica più calore sull'area e fai con la maniglia un mezzo giro in senso orario.

Non girare più di mezzo giro alla volta e aspetta un minuto tra i giri. Lascia che l'Anti-Clamp e il tempo facciano il lavoro per te.

Salta il passaggio successivo.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.