Salta al contenuto principale

Changement courroie Cricut Maker

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Francese

Traduzione in corso passo 6

Passo 6
Cricut Maker Belt Replacement: passo 0, immagine 1 di 3 Cricut Maker Belt Replacement: passo 0, immagine 2 di 3 Cricut Maker Belt Replacement: passo 0, immagine 3 di 3
  • Use a Phillips #1 screwdriver to remove the two 7 mm screws from the belt holder under the main motor.

  • Removing these two screws will cause the belt holder to detach.

  • Slip it through the hole in the main motor frame.

Utilisez un tournevis cruciforme #1 pour retirer les deux vis de 7 mm du porte-courroie sous le moteur principal.

Le retrait de ces deux vis entraîne le détachement du porte-courroie.

Glissez-le dans le trou du châssis du moteur principal.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.