Salta al contenuto principale

Cricut Maker vordere Klappe tauschen

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 2

Passo 2
Cricut Maker Front Door Replacement: passo 0, immagine 1 di 3 Cricut Maker Front Door Replacement: passo 0, immagine 2 di 3 Cricut Maker Front Door Replacement: passo 0, immagine 3 di 3
  • Remove the seven screws (Four 8.5 mm screws, and three 12.5 mm screws) on the bottom of the device, this will allow you to remove the cover later on.

  • Use a Phillips #1 screwdriver to remove the four 8.5 mm screws from the bottom of the device.

  • Use a Phillips #0 screwdriver to remove the three 12.5 mm screws.

Entferne die sieben Schrauben (vier 8,5 mm Schrauben und drei 12,5 mm Schrauben) auf der Unterseite des Geräts, damit du später die Klappe ausbauen kannst.

Verwende einen Kreuzschlitzschraubendreher #1, um die vier 8,5 mm Schrauben an der Unterseite des Geräts zu entfernen.

Verwende einen Kreuzschlitzschraubendreher #0, um die drei 12,5 mm Schrauben zu entfernen.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.