Salta al contenuto principale

Nintendo WaveBird Drahtloskontroller Oberteil austauschen

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 2

Passo 2
Nintendo WaveBird Wireless Controller Front Panel Replacement: passo 0, immagine 1 di 2 Nintendo WaveBird Wireless Controller Front Panel Replacement: passo 0, immagine 2 di 2
  • Carefully turn over the controller and place it on a flat surface.

  • Slowly separate the top panel from the bottom panel.

  • The buttons are loose and may fall off the motherboard.

  • Once separated, set aside the top panel.

  • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

Wenn die Schrauben entfernt sind, dann drehe den Kontroller herum und lege ihn auf die Arbeitsfläche.

Trenne langsam das Oberteil vom Unterteil.

Die Tasten sind lose und können von der Hauptplatine herunterfallen.

Lege das Oberteil zur Seite.

Achte beim Zusammenbau darauf, dass das Oberteil und die Tasten korrekt ausgerichtet sind, so dass die Tasten an die richtige Stelle gleiten können.

-[* black] After each screws has been removed carefully turn over the controller, and place on a flat surface.
+[* black] Carefully turn over the controller and place it on a flat surface.
[* black] Slowly separate the top panel from the bottom panel.
-[* icon_reminder] The buttons are loose and may fall off of the motherboard.
-[* black] Once seperarted set aside the top panel.
-[* icon_note] During reassembly, make sure the front panel lines up with the buttons so they slide back into place.
+[* icon_note] The buttons are loose and may fall off the motherboard.
+[* black] Once separated, set aside the top panel.
+[* icon_reminder] During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.