三星 Galaxy Note20 无线充电线圈更换

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese

Cinese

Traduzione in corso passo 3

Passo 3

Disconnect the battery

While using a pair of tweezers to hold the motherboard shield out of the way, use the pointed end of a spudger to pry up the battery press connector.
Take care to pry only under the edge of the connector to prevent damaging the socket itself and surrounding components.
To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

断开电池

使用一对镊子将主板护罩固定住时，请使用撬棒的尖端撬起电池按压连接器。
注意仅在连接器的边缘下撬动，以免损坏插座本身和周围的组件。
要重新连接这样的压接连接器，请仔细对齐并向下按压一侧，直到其卡入到位，然后在另一侧重复。不要向下压中间。如果接口未对准，则插针会弯曲，从而造成永久性损坏。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.