Salta al contenuto principale

Sostituzione lettore CD Xbox Series X

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Italiano

Traduzione in corso passo 7

Passo 7
Xbox Series X Optical Drive Replacement, Desolder the two wires: passo 0, immagine 1 di 2 Xbox Series X Optical Drive Replacement, Desolder the two wires: passo 0, immagine 2 di 2
Desolder the two wires
  • Use a soldering iron to desolder the red wire in the corner of the optical drive board.

  • Then, desolder the adjacent black wire. Use a pair of blunt tweezers to hold and pull away the wires from the board.

  • Follow general soldering safety guidelines such as wearing eye protection, working in a well-ventilated area, and washing your hands with soap and water after soldering.

  • Excessive heat may damage electrical components. Don't apply the soldering iron to the board for long periods of time.

  • When you install the original board into the replacement optical drive, solder the red wire to the solder pad labeled R. Solder the black wire to the solder pad labeled B.

Usa un saldatore per dissaldare il cavo rosso nell'angolo della scheda dell'unità ottica.

Quindi, dissalda il cavo nero adiacente. Usa un paio di pinzette a punta arrotondata per tenere e tirare via i cavi dalla scheda logica.

Segui le linee guida generali di sicurezza per la saldatura come indossare degli occhiali protettivi, lavorare in un'area ben ventilata, e lavarti le mani con acqua e sapone dopo aver saldato.

Il calore eccessivo potrebbe danneggiare i componenti elettrici. Non tenere il saldatore troppo a lungo sulla scheda.

Quando installi la scheda originale nel nuovo lettore ottico, salda il cavo rosso al pad di saldatura contrassegnato con R. Salda il cavo nero al pad di saldatura contrassegnato con B.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.