Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 1

Passo 1
Remove the following screws securing the Lightning connector assembly to the rear case:
  • Remove the following screws securing the Lightning connector assembly to the rear case:

  • One 2.9 mm Phillips screw

  • During re-installation, make sure that the headphone jack's plastic protrusion lies above the metal washer.

  • One 1.5 mm Phillips screw

  • Two 3.3 mm Phillips screws

Separa con delicatezza il gruppo altoparlante dal cavo a nastro del connettore Lightning.

Se stai sostituendo il connettore Lightning con uno nuovo, assicurati di trasferire l'involucro di gomma attorno al microfono. Puoi farlo usando uno spudger.

[* black] Gently peelRemove the speaker assembly away fromfollowing screws securing the Lightning connector ribbon cable.
[* icon_note] If you are replacing
assembly to the Lightning connector with a new partrear case:
[* red] One 2.9 mm Phillips screw
[* icon_reminder] During re-installation
, make sure to transferthat the rubber casing aroundheadphone jack's plastic protrusion lies above the microphone. You can do this using a spudger.metal washer.
[* orange] One 1.5 mm Phillips screw
[* yellow] Two 3.3 mm Phillips screws
[* black] Gently peelRemove the speaker assembly away fromfollowing screws securing the Lightning connector ribbon cable.
[* icon_note] If you are replacing
assembly to the Lightning connector with a new partrear case:
[* red] One 2.9 mm Phillips screw
[* icon_reminder] During re-installation
, make sure to transferthat the rubber casing aroundheadphone jack's plastic protrusion lies above the microphone. You can do this using a spudger.metal washer.
[* orange] One 1.5 mm Phillips screw
[* yellow] Two 3.3 mm Phillips screws

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.