Aggiusta le tue cose Community Store

iPad 6 Wi-Fi LCDの交換

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Giapponese
Passo precedente Passo successivo

Traduzione in corso passo 3

Passo 3
iPad 6 Wi-Fi LCD Replacement: passo 0, immagine 1 di 3 iPad 6 Wi-Fi LCD Replacement: passo 0, immagine 2 di 3 iPad 6 Wi-Fi LCD Replacement: passo 0, immagine 3 di 3

  • Do not attempt to fully remove the LCD. It is still connected to the iPad by several cables at the home button end. Lift only from the front-facing camera end.

  • Use the flat end of a spudger to pry the LCD out of its recess just enough to grab it with your fingers. There may be glue around the screw holes that needs to be cut with a knife.

  • Flip the iPad LCD like a page in a book, lifting near the camera and turning it over the home button end of the rear case.

  • Be gentle and keep an eye on the LCD cables as you flip the display over.

  • Lay the LCD on its face to allow access to the display cables.

  • Set the LCD down on a soft, clean, lint-free surface.

LCDを完全に取り外さないでください。まだホームボタンの端にいくつかのケーブルとiPad本体が接続されています。 前面カメラ側からのみ持ち上げます。

スパッジャーの平面側先端を使って、LCDを指で掴みやすいように、凹みからLCDをこじ開けます。 ネジ穴の周りに接着剤が付けられている場合は、ナイフで切開する必要があります。

本のページのようにiPadのLCDを裏返して、カメラの近くで持ち上げ、リアケースのホームボタンの端に向けます。

ディスプレイを裏返す時はLCDケーブルに注意してください。

LCDを正面側に向けて、ディスプレイケーブルにアクセスできるようにします。

LCDを柔らかく、清潔で糸くずの出ない布の表面に置きます。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.